[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Starting ANTS apps over Linux on different PCs

To: janos-discuss@fast.cs.utah.edu
Subject: Starting ANTS apps over Linux on different PCs
From: adotl <adotl@lion.cc>
Date: Wed, 19 Sep 2001 18:17:32 +0200
In-Reply-To: <200109191445.f8JEjmV15181@faith.cs.utah.edu>
References: <200109191445.f8JEjmV15181@faith.cs.utah.edu>
Sender: owner-janos-discuss@fast.cs.utah.edu

I was wondering if there is a way 
to start up single nodes by hand without 
using createnetworks... 

Theoretically they should just need a mapping between
active address <--> IP address....
which could be written in the config or route file...

am I missing something ??

thanks

Andreas

Follow-Ups:
- Re: Starting ANTS apps over Linux on different PCs
  - From: Timothy Stack <stack@cs.utah.edu>

References:
- Re: major/minor number mismatch ?
  - From: Timothy Stack <stack@cs.utah.edu>

Prev by Date: Re: major/minor number mismatch ?
Next by Date: Re: Starting ANTS apps over Linux on different PCs
Prev by thread: Re: major/minor number mismatch ?
Next by thread: Re: Starting ANTS apps over Linux on different PCs

[ Janos ] [ OSKit ] [ Network Testbed ] [ Flick ] [ Fluke ]
Flux Research Group / Department of Computer Science / University of Utah